Enum std::sync::mpsc::TrySendError1.0.0[][src]

pub enum TrySendError<T> {
    Full(T),
    Disconnected(T),
}
Expand description

This enumeration is the list of the possible error outcomes for the try_send method.

Variants

Full(T)

The data could not be sent on the sync_channel because it would require that the callee block to send the data.

If this is a buffered channel, then the buffer is full at this time. If this is not a buffered channel, then there is no Receiver available to acquire the data.

Disconnected(T)

This sync_channel’s receiving half has disconnected, so the data could not be sent. The data is returned back to the callee in this case.

Trait Implementations

Returns a copy of the value. Read more

Performs copy-assignment from source. Read more

Formats the value using the given formatter. Read more

Formats the value using the given formatter. Read more

👎 Deprecated since 1.42.0:

use the Display impl or to_string()

The lower-level source of this error, if any. Read more

🔬 This is a nightly-only experimental API. (backtrace #53487)

Returns a stack backtrace, if available, of where this error occurred. Read more

👎 Deprecated since 1.33.0:

replaced by Error::source, which can support downcasting

Converts a SendError<T> into a TrySendError<T>.

This conversion always returns a TrySendError::Disconnected containing the data in the SendError<T>.

No data is allocated on the heap.

This method tests for self and other values to be equal, and is used by ==. Read more

This method tests for !=.

Auto Trait Implementations

Blanket Implementations

Gets the TypeId of self. Read more

Immutably borrows from an owned value. Read more

Mutably borrows from an owned value. Read more

Performs the conversion.

Performs the conversion.

The resulting type after obtaining ownership.

Creates owned data from borrowed data, usually by cloning. Read more

🔬 This is a nightly-only experimental API. (toowned_clone_into #41263)

recently added

Uses borrowed data to replace owned data, usually by cloning. Read more

Converts the given value to a String. Read more

The type returned in the event of a conversion error.

Performs the conversion.

The type returned in the event of a conversion error.

Performs the conversion.