Customizing Builds with Release Profiles
In Rust, release profiles are predefined and customizable profiles with different configurations that allow a programmer to have more control over various options for compiling code. Each profile is configured independently of the others.
Cargo has two main profiles: the
dev profile Cargo uses when you run
cargo build and the
release profile Cargo uses when you run
cargo build --release. The
dev profile is defined with good defaults for development,
release profile has good defaults for release builds.
These profile names might be familiar from the output of your builds:
$ cargo build Finished dev [unoptimized + debuginfo] target(s) in 0.0 secs $ cargo build --release Finished release [optimized] target(s) in 0.0 secs
release shown in this build output indicate that the compiler
is using different profiles.
Cargo has default settings for each of the profiles that apply when there
[profile.*] sections in the project’s Cargo.toml file. By adding
[profile.*] sections for any profile you want to customize, you can override
any subset of the default settings. For example, here are the default values
opt-level setting for the
[profile.dev] opt-level = 0 [profile.release] opt-level = 3
opt-level setting controls the number of optimizations Rust will apply to
your code, with a range of 0 to 3. Applying more optimizations extends
compiling time, so if you’re in development and compiling your code often,
you’ll want faster compiling even if the resulting code runs slower. That is
the reason the default
0. When you’re ready to
release your code, it’s best to spend more time compiling. You’ll only compile
in release mode once, but you’ll run the compiled program many times, so
release mode trades longer compile time for code that runs faster. That is why
opt-level for the
release profile is
You can override any default setting by adding a different value for it in Cargo.toml. For example, if we want to use optimization level 1 in the development profile, we can add these two lines to our project’s Cargo.toml file:
[profile.dev] opt-level = 1
This code overrides the default setting of
0. Now when we run
Cargo will use the defaults for the
dev profile plus our customization to
opt-level. Because we set
1, Cargo will apply more
optimizations than the default, but not as many as in a release build.
For the full list of configuration options and defaults for each profile, see Cargo’s documentation.